Post a question or comment
Credit Filters
Filter by location
Forum
Topic
Replies
Recent

Disincentivizing Low Emitting Products

CI-v4 EQc2:Low-emitting materials
posted by  Michelle Rosenberger  on 

The new bundling of low emitting categories into one credit is resulting in disincentivizing our v4 projects from pursuing low emitting credits they always used to before.

1
Wed Jan 25, 2017, 6:49 pm

Facilities off-site alllowed but cannot be double counted

NC-v4 MPR2:Must use reasonable LEED boundaries
posted by  Nate Tsang  on 

Hello, I am currently working on a project and we are targeting LEED ND. As part of LEED ND, one of the buildings will be LEED NC certified.

1
Wed Mar 16, 2016, 7:17 pm

Manual Override

NC-v4 SSc6:Light pollution reduction
posted by  Donald Green  on 

Is there any circumstance whereby an after hours manual override for a Civic Building would not be acceptable for exterior lighting?

0

LEED CI MPR for existing land...

CI-v4 MPR1:Must be in a permanent location on existing land
posted by  Keith Robertson  on 

V4 cites the MPR requirement to build on already existing land as a requirement for CI projects. Isn't that a given?

1
Sat Aug 26, 2017, 6:14 pm

Prescriptive compliance

CI-v4 EAc2:Optimize energy performance
posted by  Michael Wahjudi  on 

Can a project eligible for points under Base Building Systems - Building Envelope, Opaque and Building Envelope, Glazing if they can meet most of recommendations from 50% AEDG?

1
Wed Mar 16, 2016, 11:07 pm

Envelope CxA Requirements

NC-v4 EAp1:Fundamental commissioning and verification
posted by  Risto Beatty  on 

Do the rules for who can be a CxA also apply to envelope commissioning? That is, can the envelope consultant on a project also perform the envelope commissioning?

1
Fri Apr 21, 2017, 4:29 pm

Single tenant O&M certification on a multitenant building

NC-v4 MPR2:Must use reasonable LEED boundaries
posted by  Ricardo Sá  on 

LEED O&M 2009 reference guide stated (page xxii) that "certification applies only to whole buildings" and that "the project of a multitenant building must involve at least 90% of the total gros

1
Thu May 26, 2016, 6:34 pm

Pharmaceutical Manufacturing factory project

Healthcare-v4 MPR1:Must be in a permanent location on existing land
posted by  Magda Aghababyan  on 

Hi, We are going to start a new LEED project for a pharmaceutical manufacturing facility building which will be started in a few months.

1
Sat Aug 26, 2017, 3:26 pm

Roof Assembly

CI-v4 MRc2:Interiors life-cycle impact reduction
posted by  Kerry Honsinger  on 

If we are making repairs to the exterior of the roof, can we then account for the entire roof as a roof assembly where Exterior sheathing/surface is one layer, structural elements is 2nd layer and

1
Tue Jan 17, 2017, 6:49 pm

Renewable Energy Production - point calculation

NC-v4 EAc5:Renewable energy production
posted by  juyew tang  on 

hi, i am new with this LEED. now i design for a new project. under this NC-V4, EAC5, is the point award still based on the below table? percentage of on-site renewable energy LEED point 1%

1
Thu Jul 20, 2017, 2:09 pm