See LEEDuser’s guidance on NC-2009 IEQc4.1 »
Post a question or comment
Credit Filters
Low-emitting materials - adhesives and sealants
Filter by location
Forum
Topic
Replies
Recent
Default Avatar

New Documenter - Looking for general list of selants, etc, for Div 21, 22, 23, 26

NC-2009 IEQc4.1:Low-emitting materials - adhesives and sealants
posted by  Melanie Blacklock  on 

Hi - this is my first full blown LEED job to document.  I am getting ready to send the forms to the MEP subs for them to fill out for IEQc4.1.

0
Default Avatar

Spray adhesives has VOC Contents and GREENGURAD certificate also. This material can be use?

NC-2009 IEQc4.1:Low-emitting materials - adhesives and sealants
posted by  Eunjoo Park  on 

My project located in South Korea. So I often fall into difficulties to interpretation manufacture data.

The material is "Scotch-WeldTM Hi-Strength Postforming 94 CA".

0
Default Avatar

About Spray adhesives, Material has voc g/l limit and Greenguard certificate.

NC-2009 IEQc4.1:Low-emitting materials - adhesives and sealants
posted by  Eunjoo Park  on 

My project is located in South Korea, so I open fall into difficulties to interpret manufacture data. 

0

Acceptable Documents Stating VOC Content

NC-2009 IEQc4.1:Low-emitting materials - adhesives and sealants
posted by  Abdulrahman Sherazy  on 

What are the acceptable forms of documents stating the VOC content in a material? I have the following three forms: 1. Technical data-sheet from the supplier stating the VOC content.. 2.

3
Default Avatar
mary al
LEEDuser Basic Member
0 thumbs up
Thu Dec 21, 2017, 5:16 pm

Pipe Thread Compound

NC-2009 IEQc4.1:Low-emitting materials - adhesives and sealants
posted by  Maura Adams  on 

In what category would this product be?

4
Mon Dec 18, 2017, 5:06 pm
Default Avatar

CALGreen Alternative Compliance for IEQc4.1 and 4.2

NC-2009 IEQc4.1:Low-emitting materials - adhesives and sealants
posted by  Jenelle Shapiro  on 

I'm aware of the CALGreen Alternative compliance path for achieving these two credits, but the requirement states that an approved building permit or final certificate of occupancy in order to be c

2
Tue Dec 5, 2017, 5:53 pm

Duct Seal level

NC-2009 IEQc4.1:Low-emitting materials - adhesives and sealants
posted by  Sarfaraj Khan  on 

Minimum duct seal level must comply with table 6.4.4.2A- Ashrae 90, i have this in my specification for duct and i think it apply only to G.I Duct, Not to pre insulated duct, please anyone can clar

0

Concrete additives

NC-2009 IEQc4.1:Low-emitting materials - adhesives and sealants
posted by  Peter Dyro  on 

What is the story with concrete additives?

1
Thu Feb 17, 2011, 7:18 pm

Non-domestic VOC resources

NC-2009 IEQc4.1:Low-emitting materials - adhesives and sealants
posted by  Bruce Maine  on 

I know this question has been asked before but I'm unable to locate the official USGBC interpretation for acceptable resources for VOC calculations for non-domestic projects.

1
Mon Nov 26, 2012, 5:50 pm
Default Avatar

Wood Cladding adhesives

NC-2009 IEQc4.1:Low-emitting materials - adhesives and sealants
posted by  Nouran Abdel-Rahman  on 

We are applying wood cladding for the walls. To assign the cladding panels, firstly we apply wood framing to the walls then fasten the panels to them.

1
Thu Apr 17, 2014, 2:04 pm