Forum quick links
adhesive powder
NC-2009 IEQc4.1:Low-emitting materials - adhesives and sealantsposted by Melinda Orova on
Dear All, Our project uses a cement based adhesive powder that will be mixed with water and then applied. We have data for the powder that it has 0 g/l VOC, and the applied quantity in kg.
Epoxy mortar for anchoring rebar in concrete
NC-2009 IEQc4.1:Low-emitting materials - adhesives and sealantsposted by Anna Okviana on
Hai, my project use epoxy glue for anchoring rebar from brick wall to column and slab in indoor area. Does it must meet LEED requirement for adhesive and sealant?
Adhering a Copper Shielding membrane
NC-2009 IEQc4.1:Low-emitting materials - adhesives and sealantsposted by Jonathan Weiss on
I am working on a project where we need to provide RF Shielding and are looking for how to adhere a copper sheet below an epoxy floor. The manufacturer recommends a bonding agent that is "
I recently stumbled upon a
NC-2009 IEQc4.1:Low-emitting materials - adhesives and sealantsposted by Chloe Bendistis on
I recently stumbled upon a strange requirement for aerosol adhesives in the IEQ c4.1 credit form v2009 that is NOT listed in the addenda.
Concrete Adhesives - which limit to spec?
NC-2009 IEQc4.1:Low-emitting materials - adhesives and sealantsposted by Jenelle Shapiro on
We have the following materials called out in the 03 30 00 Cast-in place concrete spec: 1. Semi-rigid joint filler 2. Bonding Agent 3.
Aerosol Adhesives
NC-2009 IEQc4.1:Low-emitting materials - adhesives and sealantsposted by Martha Norbeck on
I am at a loss for the comments made by our LEED reviewer about an aerosol adhesive. The product is a general purpose mist spray aerosol adhesive with a VOC content of 53.2% by weight.
Masonry Joint Sealant
NC-2009 IEQc4.1:Low-emitting materials - adhesives and sealantsposted by Erin Holdenried on
Hello. Would Masonry joint sealant fall in under the "Other" category for a VOC limit of 420 g/L?
VOC Limit - Thread Cutting Oils
NC-2009 IEQc4.1:Low-emitting materials - adhesives and sealantsposted by Jason Biondi on
What is VOC limit for "Thread Cutting Oils" as per SCAQMD Standards to comply with LEED requirements ?
VOC unit conversion
NC-2009 IEQc4.1:Low-emitting materials - adhesives and sealantsposted by James Chueh on
Hi, I've come across some products that are labelled with a VOC values of mg/m2/hr (milligram per meter square per hour), so how do you convert it to l/g?