Forum quick links
residential/nonresidential
NC-2009 EAp2:Minimum energy performanceposted by Francesco Passerini on
Exception a. of G3.1.1 states: "Use additional system type(s) for non predominant conditions (i.e. residential/nonresidential …)".
Existing Equipment
NC-v4 EAp2:Minimum energy performanceposted by Francesco Passerini on
The 90.1-2010 User's Manual states: "In some cases, a complete HVAC system already exists (...) the proposed building and baseline building models are the same and are based on the existing HVAC sy
Leed boundary for commercial interior
CI-2009 PIf1:Minimum Program Requirementsposted by Elena Gonzi on
Hi, I have some question about LEED Commercial Interior certification : 1) Situation: we have a offices building that has a basement in common with other two offices buildings.
mandatory provisions for systems that are not in scope of work
CS-v4 EAp2:Minimum energy performanceposted by Alessandro Speccher on
hi all, we are doing a feasibility study on a CS major renovation project located in South Italy.
light density in wellness center
NC-2009 EAp2:Minimum energy performanceposted by Francesco Passerini on
What space type shall be considered for a wellness center (e.g.
Zone Air Distribution Effectiveness
NC-v4 EQp1:Minimum indoor air quality performanceposted by Francesco Passerini on
In the office the air (cold in summer, warm in winter) is both wall supplied and ceiling supplied. The air is exhausted from the WCs.
Treatment of District or Campus Thermal Energy in LEED v4
NC-v4 EAp2:Minimum energy performanceposted by Francesco Passerini on
Can the document "Treatment of District or Campus Thermal Energy in LEED V2 and LEED 2009 – Design & Construction" be used also for LEED v.4?
French VOC emission labeling
NC-v4 EQc2:Low-emitting materialsposted by Michela Tedeschi on
Hi all Could you confirm that for General Emission Evalutation, French VOC emission labeling is accepted even if in the document http://www.usgbc.org/sites/default/files/Low%20Emitting%20Third%20Pa
Base Building Water Fixtures - No cutsheets available
CI-2009 WEp1:Water use reductionposted by Octavio Pires Junior on
Hi All, My current project is a CI office space in Rome-Italy, which has been leased from a new landlord who acquired a semi-finished building from a bank liquidation.
CHP electricity not used by the building
NC-2009 EAp2:Minimum energy performanceposted by Francesco Passerini on
I'm modeling a building where hot water is provided by a district heating system. The district heating system is a cogeneration system (CHP).